Braun AW200 RC Bedienungsanleitung Seite 12

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 13
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 11
12
attempt to synchronise had to be
interrupted (after approximately
10 min.). Push button 1 to set the
hands to the right time. When button
2 is pressed, the seconds in the
display will begin to run from «0».
After the next successful manual
reception of the signal, your AW 200
will again run exactly. Please note
that the date cannot be set manually.
Important
To ensure successful reception:
Do not place the housing of
your AW 200 on metallic
ground (includes its milanaise
steel strap).
Keep your AW 200 as still as
possible during reception.
Position your watch far from
other electrical appliances
(approximately 1m).
For reliable reception during
extremely bad conditions, the
display is switched off after
4-5 minutes.
When reception is disturbed, the
attempt to receive will be auto-
matically stopped after 10 minu-
tes. Your watch will then continue
to run as a normal quartz watch.
When switching to manual recep-
tion the display will begin to flash
with «00» and will count in one
second steps upward. During
bad reception conditions, the
display will continually return to
«00». You should then change
the position or orientation of your
AW 200.
In case your AW 200 is wrongly
adjusted, proceed as follows:
Check the reference position
(please see E).
Verify whether the time zone is
correctly set (please see F).
Check whether the last recep-
tion process was successful
(please see C).
If your AW 200 still does not work
correctly, please contact our cus-
tomer service.
You cannot manually operate
your watch during reception.
Strong climatic influences (e.g.
when your AW 200 is in the open
in cold winter temperatures) can
lead to the «bc» symbol in the
display as the cold weakens the
lithium battery. At normal tempe-
ratures, the «bc» symbol will dis-
appear again the next day. It is
then not yet necessary to change
the battery.
Please note: Do not expose to
temperatures over + 50 °C or
below –10 °C.
Subject to change without notice.
This product conforms
to the EMC-Directive
89/336/EEC.
At the end of the product's
useful life, please dispose
of it at appropriate collec-
tion points provided in
your country.
AW200_S6-16 Seite 12 Donnerstag, 12. Mai 2005 2:04
Seitenansicht 11
1 2 ... 7 8 9 10 11 12 13

Kommentare zu diesen Handbüchern

Keine Kommentare