Braun NC1000 Bedienungsanleitung PDF herunterladen (Seite 15)

• Dissolve descaling agent in 1.7 l water and fill

this mixture in the water tank (C) up to «max».

Please use 50 g of a descaling powder based on

amidosulphonic acid and citric acid.

• Remove the drip tray (N) and position a kitchen

container in its place (capacity 2 litres or more).

• Ensure that the coffee/water selector (Q) is in

the «water» position.

• Press the «stop» button (D) and keep it

depressed while pressing the manual button (H).

• The unit will start the descaling cycle. During

the whole descaling process power/stand-by

signal is flashing and the water filter exchange

signal is lit permanently.

• After approx. 20 minutes, the process stops and

the cup, mug, cappuccino and manual signals

will blink. You need to switch the coffee/water

selector to the «coffee» position.

• In the «coffee» position, the above sequence is

repeated again until the tank (C) is empty.

• Then the cup, mug, cappuccino and manual

signals will blink again. Empty the kitchen

container and place it back underneath the

pipes.

• Clean the water tank (C) and refill it with fresh,

cold water up to «max».

• To start the «automatic rinsing cycle» of the

water pipe switch the coffee/water selector to

the «water» position.

• When the cup, mug, cappuccino and manual

signals blink again, start the «automatic rinsing

cycle» of the coffee pipe by switching the

coffee/water selector to the «coffee» position.

A manual coffee cycle is run every 2 minutes

until the tank (C) is empty.

• The descaling process is finished when the

power/stand-by signal is permanently lit.

Troubleshooting

Problem Situation Solution

The machine runs out of water

during brewing.

Water tank (C) is empty.

Quantity in cup lower than

normal.

Fill the water tank (C). Press the

cup/mug or cappuccino button

to start a new coffee.

Nothing happens when the cup

button (K), mug button (J) or

cappuccino button (I) is

pressed.

No beverage delivery. Make sure that the unit is

plugged in, switched on and the

water tank (C) is full.

Cup lights are blinking one after

the other.

Brewing process has been

interrupted.

Check if liquid remains inside

the brewing unit. If yes, press

cup button (K) until empty. Then

press the «stop» button to reset.

Proceed as per section

«Preparing Hot Beverages».

Coffee is too weak even if coffee

selector is in «max» strength or

only hot water is coming out.

1. Coffee container is blocked.

2. Dosing tube (Y) is blocked.

1. Disassemble the coffee

container (A) and clean the

lid (see «Cleaning – Coffee

Container»). Disassemble

and clean the brewing unit

(U).

2. Remove the brewing unit

and the coffee container.

Then remove the dosing

tube (Y) and clean it in hot

water. Ensure all parts are

completely dry before re-

assembly.

3150350_Nescup_S6-24 Seite 16 Donnerstag, 6. Oktober 2005 3:05 15

1 2 ... 10 11 12 13 14 15 16 17 18 19 20

Kommentare zu diesen Handbüchern

Keine Kommentare

Braun NC1000 Bedienungsanleitung Seite 15

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Kaffeemacher Braun NC1000