Braun NL Series Bedienungsanleitung PDF herunterladen (Seite 49)

Page 47

Maintenance and Lubrication Schedule

Resecure, replace or correct as needed

Use Braun 32840-QT (Exxon

Univis HVI 26)

K\GUDXOLFÁXLGdo not mix with Dextron III or other

K\GUDXOLFÁXLGV&KHFNÁXLGOHYHOZLWKplatform

lowered fully and roll stop unfolded fully. Fill

WRZLWKLQßRIWKHERWWRPRIWKHßÀOOWXEH

(neck).

Tighten, repair or replace if needed.

Inspect cotter pins on platform pivot pin (2)

Hydraulic Fluid (Pump) - Check level. Note: Fluid

should be changed if there is visible contamination.

,QVSHFWWKHK\GUDXOLFV\VWHPF\OLQGHUKRVHVÀW-

WLQJVVHDOVHWFIRUOHDNVLIÁXLGOHYHOLVORZ

,QVSHFWF\OLQGHUVÀWWLQJVDQGK\GUDXOLFFRQQHFWLRQV

for wear, damage or leaks

Inspect outer barrier cylinder hose assembly (hose,

fasteners, connections, etc.) for wear, damage or

leakage (if equipped)

4500

Cycles

Perform all procedures listed in previous sections also

1500

Cycles

Resecure, replace or correct as needed.Remove pump module cover and inspect:

+\GUDXOLFKRVHVÀWWLQJVDQGFRQQHFWLRQVIRU

wear or leaks

• Harness cables, wires, terminals and connec-

tions for securement or damage

• Control board, circuit breaker, power switch and

lights for securement or damage

continued

1 2 ... 44 45 46 47 48 49 50 51 52 53

Keine Kommentare

Braun NL Series Bedienungsanleitung Seite 49