Braun RA500 Bedienungsanleitung PDF herunterladen (Seite 31)

Positive (+) battery

lead wire must be

protected by

installer-provided 25

ampere fuse or

circuit breaker.

Failure to do so may

result in serious

bodily injury and/or

property damage.

RNING

The 2 pin power harness connec-

tor and the 14-pin data harness

connector are supplied with the

ramp.

Note: Connectors are supplied

only, harnesses are supplied by

ramp installer. The ramp installer

is responsible for vehicle connec-

tions.

The ramp installer provides an

appropriate momentary contact

control switch.

Terminate the power supply,

ground and ramp data signals as

specied in the legends below.

The Positive (+) “battery” lead

wire must be protected by an

in-line 25 ampere fuse or circuit

breaker (installer provided).

Electrical Connections

RAMP INSTALLATION

Output 1 Indicator - Move Out - Normally Open (N.O.) 14 to 18 Gauge

Output 2 Indicator - Alarm - Normally Open (N.O.) 14 to 18 Gauge

Input 3 Switch - Ramp Deploy 14 to 18 Gauge

Input 4 Switch - One Touch 14 to 18 Gauge

Input 5 Indicator - Power Common Fused 14 to 18 Gauge

Output 6 Indicator - Manual Release - Normally Open (N.O.) 14 to 18 Gauge

Input 7 Ramp Enable 14 to 18 Gauge

Output 8 Switch - Common 14 to 18 Gauge

Output 9 Indicator - Full In - Normally Open (N.O.) 14 to 18 Gauge

Input 10 Switch - Ramp Stow 14 to 18 Gauge

Input 11 Switch - Park Brake (LOW) to Operate 14 to 18 Gauge

Output 12 Indicator - Move In - Normally Open (N.O.) 14 to 18 Gauge

Output 13 Indicator - Full Out - Normally Open (N.O.) 14 to 18 Gauge

Input 14 Switch - Park Brake (HIGH) to Operate 14 to 18 Gauge

Function Pin No. Description Wire Size

Input 1 Battery - 24 Volt with 25 Amp. Protection Device 10 Gauge

Input 2 Ground - Battery 10 Gauge

Wire Maximum Length: 10 Meters

Function Pin No. Description Wire Size

Notes: Either the One touch

switch or both the Deploy and

Stow switch connections should

be utilized but not both.

The Park Brake switch (either

high or low) and Ramp Enable

are required for ramp to operate.

Ramp Enable requires + Vehicle

power to operate.

See metric to US wire size con-

version chart on page 43.

Power Harness with Molex 42816-0212 Connector (installer provided)

Data Harness with AMP 206044-1 Connector (installer provided)

Page 29

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 47 48

Kommentare zu diesen Handbüchern

Keine Kommentare

Braun RA500 Bedienungsanleitung Seite 31

Kommentare zu diesen Handbüchern