Braun UVL 604XB Bedienungsanleitung PDF herunterladen (Seite 10)

Page 8

Pre-Lift Operation Notes

fully unfolded before the front

and rear wheelchair wheels (or

standee) have crossed the roll

stop.

Although the outboard roll stop is

lift-powered and fully-automatic in

operation, mechanical failures are

possible. Discontinue lift

operation immediately if the

roll stop does not operate

properly.

W

A

RNING

Discontinue lift use

immediately if any lift

component does not

operate properly.

Failure to do so may

result in serious

bodily injury and/or

property damage.

platform raises. Note: The lift

platform will not raise if the roll

stop is not in the UP position.

This is a built-in safety feature.

The LIFT DOWN function lowers

the platform to ground level. The

outboard roll stop automatically

unfolds to ramp (horizontal)

position when the platform

contacts the ground to allow the

wheelchair passenger on or off of

the lift. The roll stop must be

Bridge Plate (Inboard Roll

Stop): UVL lift models may be

equipped with an automatic or

manually operated bridge plate

(except model UVL603A). The

bridge plate bridges the gap

between the lift platform and the

vehicle floor as well as serving as

an inboard roll stop.

Automatic Bridge Plate: Auto-

matic bridge plates are spring-

loaded to raise to vertical position

when the platform extends from

the stow position. The automatic

bridge plate folds down onto the

vehicle floor as the platform

raises to floor level. The bridge

plate automatically folds down to

the platform surface during the lift

stow function. Discontinue lift

operation immediately if the

automatic bridge plate does

not operate properly.

Manual Bridge Plates: Manual

bridge plates are attendant

operated. The bridge plate rests

on the platform surface when the

lift is in the stowed position.

When the platform is fully-

extended, the bridge plate is

manually raised to the vertical

position. When the platform is

raised to floor level, the bridge

plate is manually lowered to the

vehicle floor (bridging position).

Fully-Unfolded

(Ramp position)

Outboard

Roll Stop

Outboard

Roll Stop

Electric

Actuator

Fully-Folded (Up-vertical)

Outboard Roll Stop

Automatic

Bridge Plate

(Inboard Roll Stop)

Vertical Position

Floor Level

(Bridging Position)

Vehicle Floor

Platform Below

Floor Level

Vehicle Floor

Platform at

Floor Level

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 26 27

Kommentare zu diesen Handbüchern

Keine Kommentare