Braun UVL 604XB Bedienungsanleitung PDF herunterladen (Seite 13)

Page 11

Lift Operating Instructions

STOW DOOR

DOWN

THE BRAUN

CORPORATION

86478

LIFT

DOWN

LIFT

81812

DOOR

STOW

Hand-held Switchbox

(Standard Equipment)

Optional Remote

Control Transmitter

Lift Control Switches:

The UVL

logic control system provides fully auto-

matic operation of all lift functions as well as op-

tional automatic door operators (if so equipped).

Lift functions can be performed from any position

the platform happens to be in at the time the switch

button is pushed.

There are two types of hand controls available for

the UVL - the standard hand-held control switchbox,

or the optional remote control. Both types of

controls are equipped with four push-button

switches. The functions activated by both types of

controls are the same. The switch functions are

labeled. The function of each switch is described

below.

Remote Control Note: The effective range of the

remote control is 20 feet. A range further than 20

feet does not allow an attendant to observe and

assist the lift passenger.

Control Switch Functions:

UP: From the stowed position, the LIFT UP function

deploys (extends) the platform fully. The platform

then raises to floor level height and moves inward to

the vehicle floor level position (if applicable). Note:

When the lift is in the stowed position, power doors

automatically open when the UP switch is pressed

(if so equipped).

From ground level, the LIFT UP function will first

automatically raise (rotate) the outboard roll stop to

the upright (vertical) position. Note: The lift will not

raise if the roll stop is not in the UP position (built-in

safety feature). The platform then raises to floor

level height and moves inward to the vehicle floor

level position. Note: UVL600 and UVL600X lift

models move inward to floor level position with an

“arcing” motion. UVL850 Series lift models do not.

DOWN: The LIFT DOWN function lowers the

platform to ground level (regardless of the position

of the platform) and then unfolds the outboard roll

stop to the ramp (horizontal) position. From the

stowed position, the lift will extend and then lower.

Note: When the lift is in the stowed position, power

doors automatically open when the DOWN switch is

pressed (if so equipped).

STOW: The STOW LIFT function raises or lowers

the platform to stow level and then moves the

platform inward (retracts) to the stow position.

RNING

Fold handrails down

before stowing lift.

Failure to do so may

result in serious

bodily injury and/or

property damage.

Note: The lift will not

stow with weight on the

platform (built-in safety

feature).

Fold handrails down

before stowing lift.

Failure to do so may

result in serious

bodily injury and/or

property damage.

DOOR CLOSE: When the vehicle is equipped with

automatic door openers (optional), the DOOR

CLOSE switch closes the doors. This function

operates only when the platform is stowed or fully

extended and below stow level.

Note: If any of these functions do not occur as

described, discontinue lift use immediately and

contact your sales representative or call The Braun

Corporation at 1-800-THE LIFT. One of our national

service representatives will direct you to an autho-

rized service repairman who will inspect your lift.

In event of power or equipment failure, refer to

Manual Operating Instructions to manually operate

(stow) the lift, then contact your sales representative

for further instructions.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 26 27

Kommentare zu diesen Handbüchern

Keine Kommentare

Braun UVL 604XB Bedienungsanleitung Seite 13

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Kommunikation Braun UVL 604XB