Braun 7680 Syncro System Logic Bedienungsanleitung PDF herunterladen (Seite 11)

•

Do not expose the shaver to temperatures of more than

50 °C for longer periods of time.

Display

The pilot light shows that the shaver is connected to the

mains.

The display shows the operation mode and charging

conditions of the shaver: During charging the display

shows the battery capacity symbol increasing by 20%

segments and the remaining charging time (flashing):

First charging (4 h):

The display counts down in 20 min. steps.

Subsequent chargings (1 h):

The display counts down in 5 min. steps.

The battery is fully charged. SmartLogic inside monitors

the battery and communicates «Test...ok» when it is still

well charged. Below 10 minutes remaining shaving time,

the display shows the minutes left. The «moving» plug

symbol indicates that you should charge your shaver. If

there is insufficient battery charge for a cordless shave,

either recharge the shaver or shave via the lpower supply

cord connected to the mains.

The display changes to this format when the shaver is in

the Clean&Charge.

The SmartLogic inside your shaver automatically monitors

the condition of the batteries as well as the charging/dis-

charging processes and adapts them to your personal

shaving patterns. For instance, if it is your routine to never

let the batteries run low, the SmartLogic will recognize this,

look for a pause when you are likely to not use the shaver

and completely discharge and then recharge your shaver

to recondition the batteries (every six months at the most,

and only when necessary).

For additional information, press the info key:

press once:

– to display the duration of the last shave

5491438_S 4-82 Seite 11 Donnerstag, 29. November 2001 2:56 14

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 78 79

Keine Kommentare

Braun 7680 Syncro System Logic Bedienungsanleitung Seite 11