Braun HAIRPERFECT HC 20 Bedienungsanleitung PDF herunterladen (Seite 5)

Charging the clipper (HC 50 only)

Connect the clipper to the mains with the on/off switch (6) in position «off»

and charge it for at least 8 hours. The pilot light (7) indicates that the clipper

is connected to the mains. Once the clipper is completely charged, use it

without the cord until discharged. Then recharge to full capacity again.

A full charge will give up to 30 minutes of cordless trimming depending on

your hair. However, the maximum capacity will only be reached after

several charging/discharging cycles.

Best environmental temperature range for charging is 15 °C to 35 °C.

If the rechargeable battery is discharged, you may also operate the clipper

via the mains cord. (If the clipper does not run immediately, charge it for

approx. 1 minute in the «off» position.)

General

The person whose hair you want to cut should sit in a position where the

top of the head is at your eye level.

The hair should be clean, well combed, tangle-free and dry.

Ensure you have a firm, but relaxed grip on the clipper.

If you are not used to clipping hair, begin with a higher setting and then

reduce the setting to avoid cutting more hair than desired.

Use a slow and controlled movement. Do not force the clipper through

the hair faster than the clipper can cut it.

In between, shake or blow off the hair from the clipper. If too much hair

is caught in the distance comb, remove and clean it.

To control your progress during clipping, regularly comb the hair in the

style desired.

Normal clipping

Push the distance comb (1) onto the hair clipper until it locks. The hair

length selector (5) must be in position «1».

To choose the desired length setting (4), push down the length selector and

shift it upward. To start clipping, shift the on/off switch (6) to «on».

Keep the distance comb flat on the hair, parallel to the head, and slowly

move against the direction of hair growth. The distance comb can only be

taken off when the length selector is set to «1».

5605456_P4-66 Seite 5 Donnerstag, 23. März 2006 9:40 09

1 2 3 4 5 6 7 8 9 10 ... 61 62

Keine Kommentare

Braun HAIRPERFECT HC 20 Bedienungsanleitung Seite 5