Braun SE 7280 SILK EPIL XPRESSIVE Bedienungsanleitung PDF herunterladen (Seite 15)

15

d Release buttons

e Trim/shave selector

f Cutter block

g Shaver head base

Shaving

Put on the shaver head attachment (7) by

clicking it in.

Pressing one of the lock keys, turn the

switch clockwise to setting 2.

Make sure the trim/shave selector is in the

«shave» position.

For best results, always make sure that

both, the shaver foil (b) and the trimmer (c)

are in contact with the skin (A). Keeping

your skin stretched (B), slowly move the

appliance against the direction of hair

growth. The trimmer first raises all long

hairs and cuts them off. Then the flexible

foil follows to smooth away any stubble.

When shaving or trimming in sensitive

areas, make sure that you always keep

your skin stretched to avoid injuries.

Contour trimming

For trimming precise line and contours, lock

the long hair trimmer by sliding the trim/

shave selector (e) to the position «trim» (C1).

Pre-cutting hair for epilation

If you choose to pre-cut your hair to the ideal

length for epilation, place the OptiTrim comb

(a) onto the shaver head. Slide the trim/shave

selector to the «trim» position.

Hold the appliance with the OptiTrim comb

lying flat on the skin. Guide it with the comb

tips against the hair growth as shown in

illustration C2.

N.B. As hair does not always grow in the

same direction, also guide the appliance

slightly diagonally or in different directions in

order to achieve best results.

•

•

•

•

•

Cleaning the shaver head

After each use, unplug the appliance.

Brush cleaning

Press the release buttons (d) to remove the

shaver head (D1). Tap the bottom of the

shaver head gently on a flat surface (not on

the foil).

Brush out the cutter block and the inside

of the shaver head. However, do not clean

the shaver foil with the brush as this may

damage the foil.

Cleaning with water

Press the release buttons (d) to remove the

shaver head. Rinse the shaver head and the

cutter block separately under running water

(D2). Leave the cutter block and the foil frame

to dry separately before reattaching them.

Keeping your shaver head attachment in

top shape

The shaving parts need to be lubricated

regularly every 3 months (E). If you clean

the shaver head under running water,

please lubricate it after every cleaning.

Apply some light machine oil or vaseline to

the shaver foil and the metal parts of the

long hair trimmer. Then remove the shaver

head and also apply a tiny amount of

vaseline as shown in picture section (E).

The shaver foil and the cutter block are

precision parts that wear out with time. To

maintain optimum shaving performance,

replace your foil and cutter block when you

notice a reduced shaving performance.

Do not shave with a damaged foil or cord.

How to replace the shaving parts

Shaver foil: Press the release buttons to

remove the shaver head. To remove the

shaver foil, press the foil frame (F). To

•

•

•

•

•

•

98579924_SE_7280_MN.indd 1598579924_SE_7280_MN.indd 15 17.03.2008 15:16:10 Uhr17.03.2008 15:16:10 Uhr

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 105 106

Kommentare zu diesen Handbüchern

Keine Kommentare