Braun Stimuplex HNS 11 HNS 11 Bedienungsanleitung PDF herunterladen (Seite 17)

Safety information

The nerve stimulator should not be used on patients with

implanted electrical devices (e.g. cardiac pacemakers) without

prior consultation with an appropriate medical specialist. Possible

interference with the implanted devices by the stimulation current

could represent a danger to the patient.

The adhesive electrodes must not be applied in the area of injuries.

The Stimuplex

HNS 11 nerve stimulator must not be used in areas

where there is an explosion hazard.

The Stimuplex

HNS 11 nerve stimulator must not be used close to

microwave therapy equipment. The possible pick-up of radio

frequency currents by the stimulation electrode could damage the

nerves.

The patient current should not drop below a specific value (please

refer to p. 21 points 8 and 9).

If the battery has leaked, the Stimuplex

HNS 11 must not continue

to be operated for safety reasons. It must be returned to the

manufacturer for correct cleaning. The same applies if any liquid

soaks through!

In the event of warning tone sequences (tone groups of approx.

6 Hz), the Stimuplex

HNS 11 must be switched off and returned to

the manufacturer or distributor for repair.

Error messages

When the Stimuplex

HNS 11 nerve stimulator is switched on, it

automatically carries out a self-test. If this detects a faulty function,

the fault is shown on the corresponding error code on the LCD

display. The Stimuplex

HNS 11 is then no longer operational. It

must be returned to the manufacturer for repair. You should state

the error code in the repair order.

The following error codes are possible:

- F1: Analogue data acquisition is faulty

- F2: Error in the program

- F3: Reference error in the analogue data acquisition system

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 27 28

Keine Kommentare

Braun Stimuplex HNS 11 HNS 11 Bedienungsanleitung Seite 17