Braun KF 190 Bedienungsanleitung PDF herunterladen (Seite 8)

When the froth starts to raise, lower the receptacle in

order to keep the ring above the froth. After frothing,

turn the function switch to position «off».

However, if you want to keep prepared coffee warm,

turn the function switch back to « ».

To heat up liquids (milk or chocolate), remove the jet (13)

and immerse the frothing attachment.

It is best to clean the frothing attachment (12) and its

removable jet (13) immediately after frothing. Remove

the frothing attachment by squeezing both plastic pins

and pulling it off downwards. Then pull off the removable

jet from the frothing attachment.

After cleaning, push the jet onto the frothing attachment

and put the frothing attachment back on the tube by

clicking it in.

D Cleaning

Always unplug the appliance before cleaning.

Never clean the appliance under running water, nor

immerse it in water; only clean it with a damp cloth.

All removable parts can be cleaned in a dishwasher.

E Decalcifying

(without illustrations)

With decreasing frothing performance or prolonged

coffee brewing time, you should decalcify both the

steam section and the coffee section of the appliance.

For decalciﬁcation use only commercial vinegar

essence solution of 25%.

N.B.

: If you have installed a water ﬁlter cartridge (7),

you absolutely have to replace it with the space

compensator (6) for the decalciﬁcation process.

First decalcify the steam section:

For decalciﬁcation of the steam section ﬁll the small tank

(9) half with water and ﬁll up to the maximum with

vinegar essence.

Remove the fr

othing attachment and hold the steam

tube into a water ﬁlled receptacle.

Make sure to immerse the steam tube opening in the

water in order to prevent steam from escaping which

can cause an offensive smell.

Stop the pumping action after about half a minute and

allow the solution to rest for 10 minutes. Then pump

through completely. Repeat the procedure twice.

After pumping the decalcifying solution through the

tube, reﬁll the small tank with cold water at least twice

and pump it through with the frothing attachment

removed.

Then decalcify the coffee section:

1. Fill the large tank (5) to the mark for 3 cups with cold

water.

2. Add vinegar essence to the mark for 6 cups.

3. Place the carafe with the lid onto the hotplate (14),

close the ﬁlter holder (10) (without any type of ﬁlter)

and switch on the coffeemaker.

4. Allow the decalcifying solution to run through.

5. Repeat this procedure at least three times with a

newly prepared descaling solution, in order to remove

all calcium residues.

6. Allow the maximum amount of fresh cold water to run

through at least twice to cleanse the machine.

Subject to change without notice.

This product conforms to the EMC-

Requirements as laid down by the Council

Directive 89/336/EEC and to the Low Voltage

Regulation (73/23 EEC).

3123150_KF_190 Seite 8 Montag, 26. Januar 2004 2:38 14

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 39 40

Kommentare zu diesen Handbüchern

Keine Kommentare

Braun KF 190 Bedienungsanleitung Seite 8

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Kaffeemaschinen Braun KF 190