Braun SI 8590 EU Bedienungsanleitung PDF herunterladen (Seite 9)

9

To turn on the iron again, just move it.

When the «auto-off» pilot light stops

flashing, the electrical power is on again.

E Textile Protector

Before attaching the Textile Protector

for the first time, iron approximately

2 minutes without the Textile Protector.

The Braun Textile Protector protects

delicate fabrics from heat damage and

makes it possible to iron most dark fabrics

without an intermediate cloth. To check

the reaction of your fabrics before you

start ironing, we recommend that you iron

a small section of material on the reverse

side. With the Protector, you are able to

iron delicate fabrics with the temperature

setting «

•••

» or «

max

», so that you can

use all steam functions your iron offers.

After having attached the Textile Protec-

tor, wait about 1

1

/

2

minutes before you

start ironing. Always store your iron with

the Textile Protector detached.

F After ironing

Unplug the iron. To prolong the life of the

iron, empty the water tank. Store the cool

iron in a dry place always standing on its

heel rest.

G Maintenance and cleaning

To clean the sole plate, use steel wool.

Never use a scouring pad, vinegar or other

chemicals.

H Cleaning the anticalc valve

The anticalc valve on the steam regulator

has to be decalcified regularly (e.g. when-

ever steam development is insufficient).

For this, the water tank has to be empty

.

Removing the steam regulator with the

anticalc valve

Turn the steam regulator clockwise to the

double arrow at the end of the anticalc

section and it will lift. Pull it out vertically.

Do not touch the anticalc valve at its lower

end. Immerse the anticalc valve in vinegar

(not vinegar essence) or lemon juice for

minimum 30 minutes. Brush off remaining

residues and rinse under running water

(fig. H 1-5).

Re-inserting the steam regulator

To re-insert the steam regulator follow fig.

6 and 7.

Notice:

The iron must not be used without

the steam regulator.

I Decalcifying/anticalc system

In order to clean the steam chamber from

residues, decalcify it as shown in fig.

I 1-11.

Caution:

Hot water and steam will come

out from the sole plate when the steam

regulator is turned clockwise into the

anticalc area.

Wait for the sole plate to cool down, then

clean it as described above.

Then refill the tank with water, heat up

the iron and press the power shot button

4 times to rinse the iron before ironing

(I 12-13).

Do not use commercial decalcifiers, they

may damage the iron.

J Trouble-shooting guide

Subject to change without notice.

This product conforms to the EMC-

Directive 89/336/EEC and to the Low

Voltage Regulation 73/23 EEC.

Problem Remedy

Drops coming

out of the steam

vents

Turn the steam

regulator anti-clock-

wise to reduce the

steam or turn it off.

Take longer intervals

when pressing the

«jet», power shot or

steam plus button.

«jet» of steam

does not function

Press the «jet» button

several times.

Less steam

develops or no

steam at all

Check water level.

Clean the anticalc

valve.

Calcium particles

coming through

the steam vents

Decalcify the steam

chamber.

SI8000_MN_S6-72 Seite 9 Freitag, 21. März 2003 1:24 13

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 55 56

Kommentare zu diesen Handbüchern

Keine Kommentare