Braun SERIES3 5772 Bedienungsanleitung PDF herunterladen (Seite 9)

9

and will go off after approx. 4 hours when

cleaning is finished.

Automatic cleaning

Once the shaver is put into the

Clean&Renew™, it is cleaned automatically

(see «C Clean&Renew™»). Manual

cleaning is recommended only when the

Clean&Renew™ is not available, e. g. when

travelling.

Manual cleaning

The hand-held unit should be detached from

the power supply cord before cleaning. The

shaver should not be used until it has dried.

Regular cleaning ensures better shaving

performance. Rinsing the shaver head under

running water after each shave is an easy

and fast way to keep it clean:

Switch the shaver on (cordless) and rinse

the shaver head under hot running water.

You may use liquid soap without abrasive

substances. Rinse off all foam and let the

shaver run for a few more seconds.

Next, switch off the shaver, remove the

shaver Foil & Cutter cassette (1) and let it

dry.

If you regularly clean the shaver under

water, then once a week apply a drop of

light machine oil onto the long hair trimmer

(2) and shaver Foil & Cutter cassette (1).

Alternatively, you may clean the shaver using

a brush:

Switch off the shaver. Remove the shaver

Foil & Cutter cassette and tap it out on a

flat surface.

Using a brush, clean the inner area of the

shaver head. However, do not clean the

shaver Foil & Cutter cassette with a brush

as this may damage it.

Replacement light for shaving parts/Reset

To maintain 100% shaving performance,

replace the shaver Foil & Cutter cassette (1),

when the replacement light for shaving parts

(8) comes on (after about 18 months) or when

worn.

•

•

•

•

•

The replacement light will remind you during

the next 7 shaves to replace the foil and

cutter cassette. Then the shaver will auto-

matically reset.

After you have replaced the Foil & Cutter

cassette (1), press the on/off switch (4) for at

least 5 seconds to reset the counter.

While doing so, the replacement light blinks

and goes off when the reset is complete. The

manual reset can be done at any time.

Preserving the batteries

In order to maintain the optimum capacity

of the rechargeable batteries, the shaver

has to be fully discharged (by shaving) every

6 months approximately. Then recharge the

shaver to full capacity.

Environmental notice

This appliance contains rechargeable

batteries. To protect the environment,

do not dispose of the appliance in the

household waste at the end of its useful life.

Disposal can take place at a Braun Service

Center or appropriate collection sites.

C Clean&Renew™

Braun Clean&Renew™ has been developed

for cleaning, charging and storing your shaver.

Clean your shaver daily in the Clean&Renew™.

During the automated cleaning process, the

shaver is switched on and off at intervals

to obtain best cleaning results. Since the

specially formulated cleaning fluid contains a

small amount of oil, the cleaning procedure

also fulfils the lubrication needs of the shaver.

Important

Only use the power supply special cord set

supplied with the shaver.

In order to avoid any leakage of the

cleaning fluid, place the appliance on a flat,

stable surface. Do not tip, move suddenly

or transport in any way if a cleaning

cartridge is installed.

•

•

98970015_Floater390cc_NA_S6-28.i9 998970015_Floater390cc_NA_S6-28.i9 9 02.04.2009 9:39:54 Uhr02.04.2009 9:39:54 Uhr

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 25 26

Kommentare zu diesen Handbüchern

Keine Kommentare