Braun AW200 RC Bedienungsanleitung PDF herunterladen (Seite 11)

11

move to the reference position

(12 o’clock). After 5 seconds the

right time will be set automatically.

If the hands do not stop at the

12 o’clock position, use button 1

to manually move the hands to the

correct reference position (briefly

press the button for moving in

single-minute steps or press and

hold it for moving fast forward).

When the hands reached the

12 o’clock position, press button 2

to confirm the reference position.

The right time will be set

immediately.

Resetting time zone (F)

To adapt the time when you are

travelling, press button 1 for

2 seconds until «+0» is displayed.

Then press «x» times button 2 for a

negative time difference from CET*

or button 1 for a positive time dif-

ference from CET*. After 5 seconds

the hands will adapt to the new time

setting.

Energy-saving mode (G)

The energy-saving mode should

only be used when the AW 200 is not

worn for a longer period of time.

Press buttons 1 and 2 for more than

5 seconds to enter the energy-

saving mode. In this mode the hands

remain at 10.10 o’clock and the

display shows a flashing point.

Attempts to synchronise will be

reduced to a minimum. You can

easily quit the energy-saving mode

by briefly pressing button 1 or 2

when the «successful-reception-

symbol» is displayed. When

reception fails, more attempts to

receive will not be made because of

energy-saving reasons. For safety

reasons, your AW 200 can now only

be operated by pressing buttons 1

and 2 for more than 5 seconds. As

soon as the «successful-reception-

symbol» appears in the display,

press button 1 or 2 briefly. At this

point we highly recommend manual

reception.

Battery change (H)

When the battery is empty, the «bc»

symbol will flash on the display. The

watch has a reserve capacity to last

for one week. After this, the hands

will remain in the 12 o’clock position.

Please note: The battery should be

changed by a watch expert only!

Battery to be used:

Lithium CR 1616

Do not dispose of empty

batteries in the household

waste. Take them to

special local collection

sites.

When the battery is changed, your

watch loses the time information it

has stored and consequently syn-

chronises automatically. If it is not

able to receive a signal (it may be

outside the transmission range or

there may be interference), the

hands can be set as follows:

«88» in the display signals that the

*Central European Time

AW200_S6-16 Seite 11 Donnerstag, 12. Mai 2005 2:04

1 2 ... 6 7 8 9 10 11 12 13

Kommentare zu diesen Handbüchern

Keine Kommentare