Braun CC20 Lady Braun Epilette 2 Bedienungsanleitung PDF herunterladen (Seite 3)

Englisch

Hair removal with the Lady Braun

Epilette 2 is easy, long-lasting and

hygienically clean. The special split

level tank gives ypu a constant flow

of clean wax. There’s no stopping of

clean wax. There’s no stopping and

waiting in between, and that makes

hot-wax depilation faster and more

convenient than ever before. The

wax temperature is continuously

variable and the thermostat keeps it

constant at just the right level for

your skin’s semsotovoty whether you

choose to use normal or low

temperature waxes.

Caution

This appliance was constructed for

heating wax only. Never use it for

any other substance. Do not connect

the appliance to unearthed sockets.

Never turn the appliance on without

wax in the tank. Place the appliance

on dry surfaces only.

Never immerse the appliance in

water.

Keep the appliance out of the reach

of children.

Do not leave the appliance plugged

in, if you are not using it.

Do not remove the filter when the

appliance is cold. Should the

appliance malfunction, disconnect it

and take it to a Braun service center.

We do not recommend using the

appliance with less than 200 g of

wax.

Technical Specifications

Voltage/wattage: see type plate at

the bottom of the appliance

Max. capacity: 850 g

Max. quantity of wax to be used: 700

Use tank (lower level):

thermostatically controlled

temperature

Filter tank (top level):

fixed temperature

Lady Braun Epilette 2 consists of:

a) Main tank

b) Filter tank (removable for cleaning)

c) Cover

d) Storage drawer for applicators

e) Cleaning edge for applicators

f) 200 g of low temperature

cosmetic wax

g) Temperature control

h) Large applicator (e.g. for legs)

Small applicator (e.g. for small

areas/facial application)

Connecting

Check first whether the voltage

printed on the bottom of the

appliance corresponds with your

local voltage. Put the wax (f) into the

filter tank (b). Connect the plug to the

socket. That automatically turns the

appliance on.

How to use

Switch

Your wax heater can be used with

either normal temperature or low

temperature waxes. The red scale

helps you choose a comfortable

temperature if you are using normal

wax. For low temperature waxes use

the green scale.

When using with 200 g of wax

Set the temperature control (g) at the

midway position for approximately 5

minutes. Then set the temperature

control to «minimum». As soon as

the wax begins to melt, stir it

occasionally.

The wax will be ready to use after

about 10 minutes.

Test the temperature by dipping the

applicator into the wax. The

temperature is right, if the wax does

not drip from the applicator. (If it

does, the wax is too hot, which may

cause skin irritation.) If the wax is too

hot, set the temperature control

down (towards «minimum»). If the

consistency is too thick, set the

temperature control a little higher

(towards «maximum»).

Before applying the wax, check

whether the temperature is adequate

for your skin’s sensitivity by dotting a

little wax on the back of your hand.

Once set, the thermostat will keep

the temperature constant. The tem-

perature in the filter tank is controlled

independently to ensure quick

melting/filtering of the wax.

When unsing with 500 g of wax

Set the temperature control (g) to

«maximum» for about 15 minutes.

Then turn the temperature control

down to «minimum». Proceed as

described under «When using with

200 g of wax».

Application e.g. on legs

For good results, your hair should be

at least 3 mm long. You should not

use the Lady Braun Epilette 2 after

sunbathing. Wait at least 24 hours.

Before you start, your skin should be

dry and free of creams, etc. Use a

little talcum, if necessary.

Stroke your leg against the direction

of hair growth with your hand to raise

the hair.

Using the large applicator, apply a

layer of wax about 15 cm long and 5

cm wide starting at the top and

working downward (1). Lift up the

bottom part of the strip slightly as

soon as you have put the wax on

your skin. That will give you a firmer

hold when pulling it off.

Do not let the wax get too hard.

Otherwise, it will dry and crumble

when you try to remove it.

Pull the strip off as soon as your

fingertip no longer sticks to the wax

when touching it.

Pull the strip of wax in one stroke

from the bottom towards the top, i.e.

against the direction of hair growth

Repeat the pocedure, until your legs

are completely smooth and free of

hair.

Should there be spots of wax that

did not come off when removing the

strip of wax the first time, apply a

little more hot wax over the spot and

pull off again after cooling. Or put a

little alcohol on a cotton pad and

moisten the spot of wax with it. After

removing hair with the Lady Braun

Epilette 2, apply a facial tonic and,

finally, a good moisturizing cream or

lotion.

Facial application

Stroke an even layer of wax using

the small applicator to your upper

lip. Work it from top to bottom and

towards the sides. Allow the wax to

cool off briefly and pull off in one

stroke towards the inside.

Apply a litle facial tonic and then a

good moisturizing cream.

Continuous filtering

Put the used strips of wax in the filter

tank 2. The wax will melt quickly and

flow through the filter mesh into the

use tank to mix with the wax there.

Important: Always stir the wax briefly

before using it.

Cleaning the filter

Once you have finished, keep the

appliance plugged in until all the wax

in the filter tank has melted

completely. Then clean the

applicators on the metal edge (e).

Take the filter tank out of the

appliance 3 and, using the small

applicator, empty the hair caught in

the filter tank onto a thick piece of

paper. Hold the filter tank by the

plastic rims only 3, as the metal

parts get hot.

Replace the filter tank and unplug

the appliance. Wait a few minutes for

the appliance to cool off before

putting the cover (c) back on.

The storage drawer (d) offers con-

venient storage for the applicators.

Keep the filtered wax in the wax

heater. It can be used several times.

However, a certain amount of wax

will be used up during every appli-

cation. Add a little new wax the next

time you use the Lady Braun

Epilette 2.

After several applications, cosmetic

wax loses its pliancy. Replace it

entirely when it starts to crumble:

Heat the wax until it becomes soft

and remove it from the wax heater

with the applicator.

Subject to change without notice.

This product conforms to the

European Directives EMC

89/336/EEC and Low Voltage

73/23/EEC.

4874481_Epilette.indd 3 20.02.2006 15:24:59 Uhr

1 2 3 4 5 6 7 8 ... 12 13

Kommentare zu diesen Handbüchern

Keine Kommentare

Braun CC20 Lady Braun Epilette 2 Bedienungsanleitung Seite 3

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Kosmetik Zubehör Braun CC20 Lady Braun Epilette 2