Braun 7526 Bedienungsanleitung PDF herunterladen (Seite 11)

Before using Clean&Renew™

For the ﬁ

rst charge of the shaver, connect the special

cord set directly to the shaver, charge it for 4 hours and

shave at least once.

Only then can the shaver be cleaned or recharged in the

Clean&Renew™.

If the rechargeable batteries are discharged, select the

combined «clean + charge» program rather than the

«clean» program alone.

Installing the cartridge

Press the lift button (12) to open the housing.

Hold the cartridge down on a ﬂat, stable surface

(e.g. table). Carefully remove the lid from the cartridge.

Slide the cartridge into the base as far as it will go.

Slowly close the housing by pushing it down until it

locks.

Replacing the cartridge

After having pressed the lift button to open the housing,

wait for a few seconds before removing the used car-

tridge.

Before discarding the used cartridge, make sure to

close the openings using the lid of the new cartridge,

since the used cartridge will contain contaminated

cleaning solution.

Operating your Clean&Renew™

• Use the special cord set from your shaver and plug it

into the Clean&Renew™ and then into an electrical

outlet.

Open the contact bow (13) by pressing the release

button (14). After shaving, switch the shaver off and

place it upside down into the Clean&Renew™

(without having released the shaver foil).

• Select the operation mode by toggling with the

mode selector (15):

clean (about 15 min)

clean + charge (about 75 min)

charge (about 60 min)

The corresponding lights will come on.

(With cord shavers, only the «clean» function can be

selected.)

old

new

7526

5493311_NA7526_S4-38 Seite 11 Mittwoch, 21. September 2005 3:07 15

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 34 35

Kommentare zu diesen Handbüchern

Keine Kommentare

Braun 7526 Bedienungsanleitung Seite 11

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Rasierer für Männer Braun 7526